B.40 – HP 3PAR Remote Copy Software User Manual
Page 176
B.40
setrcopygroup
Remote Copy User’s Guide
InForm OS Version 2.3.1
recover
Used for groups on which the
failover
operation has already been run. Changes
matching primary volume groups on the backup system to secondary volume groups
and then starts and synchronizes all groups.
restore
Used on groups on which the
recover
operation has already been run. Returns all
groups to their natural direction and starts them.
Specifies the name of the volume group whose policy is to be set, or whose target
designation is to be switched.
Specifies the target name for the target definition created with the
creatercopytarget
command (see
Specifies the time period in units of seconds (
s
), minutes (
m
), hours (
h
), or days (
d
), for
automatic resynchronization (e.g.
14h
for 14 hours). The time must be longer than or
equal to five minutes and not more than one year in duration, or set to zero to indicate
that no period should be used. This specifier can only be used with the
period
subcommand.
Specifies the mode,
sync
or
periodic
, to which the group is set. This specifier can only be
used with the
mode
subcommand.
RESTRICTIONS
■
This command requires the 3PAR Remote Copy license. Contact your local service provider
for further information.
■
When issuing the
setrcopygroup
command, either the
specifier or the
specifier must be specified.
■
Reversing the direction of primary volumes will result in the loss of any data changed after
the group was stopped.
■
The period can be set only for groups whose mode is asynchronous periodic (see