HP 3PAR Remote Copy Software - Manual (Page 325)

C.107 Synchronous Long Distance Remote Copy for Data Migration
InForm OS Version 2.3.1 Remote Copy User’s Guide
14 Begin failover on InServC to change the secondary volume group (Group1.r96) to the
primary volume group by issuing the setrcopygroup failover
command on InServC.
This command causes all indicated secondary groups (in this example, Group1.r96) to
become primary, thereby allowing changes to be made to all virtual volumes in the group.
# setrcopygroup failover Group1.r96
Are you sure that you wish to perform this action?
select q=quit y=yes n=no: y
failover started with tasks: 7567
root@xnodeed08:S63# waittask -v 7567
Id Type Name Status Phase Step
-------StartTime------- -FinishTime-
7567 remote_copy_failover Group1.r96 active 1/3 0/1 2009-08-19 14:26:51 PDT
-
Detailed status:
2009-08-19 14:26:51 PDT Created task.
2009-08-19 14:26:51 PDT Begin Failover operation on group Group1.r96
started.
2009-08-19 14:26:51 PDT Push check Check confirmed that data does need to be pushed
from target InServB to group Group1.r96.
2009-08-19 14:27:01 PDT Pushing Pushing newer data from target InServB to
group Group1.r96.
2009-08-19 14:27:01 PDT Waiting Waiting for synchronization of group
Group1.r96 to target InServB to complete.
2009-08-19 14:27:16 PDT Pushed Completed push of newer data from target
InServB to group Group1.r96.
2009-08-19 14:27:18 PDT Switched Group Group1.r96 was switched from
secondary to primary.
2009-08-19 14:27:18 PDT Starting Starting group Group1.r96 to target InServB.
2009-08-19 14:27:22 PDT Started Remote copy was started for group
Group1.r96 and target InServB.
2009-08-19 14:27:22 PDT Completed Group Group1.r96 failover completed