HP 3PAR Remote Copy Software - Manual (Page 172)

B.36 setrcopygroup
Remote Copy User’s Guide InForm OS Version 2.3.1
OPTIONS
-t
Specifies that the setrcopygroup command be applied to all
relevant groups of the indicated target. If no group names are specified, then all groups in
that target that are in the correct state for the specified subcommand will have it applied
to them. For groups with multiple targets, this option must be specified for the recover ,
restore , reverse , and pol subcommands.
-f
Does not ask for confirmation for disaster recovery commands.
-nostart
Specifies that groups are not started after the role reversal is completed through the
recover and restore specifiers.
-nosync
Specifies that groups are not synced after the role reversal is completed through the
recover and restore specifiers.
-discard
Specifies that if a group has multiple targets that group does not check with its other
targets to see if newer data should be pushed from them. This option is only valid if
failover is used as the specifier.
–nopromote
Specifies that the synchronized snapshot of groups that are switched from primary to
secondary with the reverse specifier not be promoted to the base volume. This option is
only valid for the reverse specifier. When used with the failover specifier it indicates that
snapshots of groups that are switched from secondary to primary should not be promoted
to the base volume in the case where all volumes of the group were not synced to the same
time point.The incorrect use of this option can lead to the primary and secondary volumes
not being consistent.
–nosnap
Specifies that snapshots are not taken of groups that are switched from secondary to
primary. Additionally, existing snapshots are not deleted if groups are switched from
primary to secondary.
-stopgroups