HP 3PAR Remote Copy Software - Manual (Page 175)

B.39 setrcopygroup
InForm OS Version 2.3.1 Remote Copy User’s Guide
no_auto_recover
Specifies that if the Remote Copy is stopped as a result of the Remote Copy links
going down, the group must be restarted manually after the links come back up
(default).
over_per_alert
If a synchronization of a periodic Remote Copy group takes longer to complete than
its synchronization period, an alert will be generated. This is the default behavior.
no_over_per_alert
If a synchronization of a periodic Remote Copy group takes longer to complete than
its synchronization period then an alert will not be generated.
If no policy is specified, the no_fail_wrt_on_err and no_auto_recover policies are
implemented by default.
Specifies the operation of the group(s). Valid operations are:
reverse
Changes the natural and current direction of all specified groups. The operation is
mirrored resulting in a direction change on both systems.
failover
Changes secondary volume groups to primary volume groups on the primary system
in the event of a server failure. If the group has multiple targets it will also attempt
to pull more recent data from other targets and start Remote Copy to those targets
when complete.
NOTE: When issuing the setrcopygroup command, either
the specifier or the specifier must be specified.
NOTE: The reverse specifier is not to be used as part of the normal disaster
recovery process. See Chapter C, Example Setup and Disaster Recovery for disaster
recovery procedures.