HP 3PAR Remote Copy Software - Manual (Page 253)

C.35 1-to-N Unidirectional Asynchronous Periodic Disaster Recovery Example
InForm OS Version 2.3.1 Remote Copy User’s Guide
5 On the restored system (InServ1), issue the showrcopy command and verify that the
target (InServ2) displays ready, the sending links display Up, and the volumes are
Syncing as shown in bold in the following example:
If I/O is continuing to be applied to the volumes on storage server InServ2, you must stop
I/O and perform a final manual synchronization before the original setup can be restored as
shown in the following example:
On InServ1:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
InServ2 11 IP ready mirror_config
InServ3 12 IP ready mirror_config
Link Information
Target Node Address Status Options
InServ2 0 10.100.33.63 Up
InServ2 1 10.101.33.63 Up
InServ3 0 10.100.33.11 Up
InServ3 1 10.101.33.11 Up
receive 0 10.100.33.63 Up
receive 1 10.101.33.63 Up
Group Information
Name Target Status Role Mode Options
periodic_group_1 InServ2 Started Secondary-Rev Periodic Last-Sync Thu Dec 14
18:19:17 PST 2006 , over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
localvv.0 413 remotevv.0 21 Syncing Thu Dec 14 18:40:14 PST 2006
localvv.1 414 remotevv.1 22 Syncing Thu Dec 14 18:39:03 PST 2006
Name Target Status Role Mode Options
periodic_group_2 InServ3 Started Primary Periodic over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
localvv.2 23 remotevv.0 385 Syncing NA
localvv.3 24 remotevv.1 386 Syncing NA
On InServ2:
# syncrcopy periodic_group_1