HP 3PAR Remote Copy Software - Manual (Page 129)

A.3 Setting Up the Remote Copy Transport Layer for RCFC
InForm OS Version 2.3.1 Remote Copy User’s Guide
A.2 Setting Up the Remote Copy Transport Layer for RCFC
Table A-2 summarizes how to configure the Remote Copy pair for RCFC.
A.3 Setting Up Remote Copy
Table A-3 summarizes how to set up a bidirectional Remote Copy pair and to then begin using
the Remote Copy software.
■ For unidirectional configurations, follow steps 1 through 10 in Table A-3 . If necessary,
repeat the steps for each additional Remote Copy pair up to a maximum of four pairs.
■ For N-to-1 Remote Copy configurations, follow steps 1 through 10 in Table A-3 to set up
the first pair in the configuration. Repeat the entire process for each additional pair up to a
maximum of four pairs.
Table A-2. RCFC Setup
Step Reference Primary System Backup System
1 Setting Up the
Remote Copy
Interface for
RCFC on
page 3.14
For each Fibre Channel
adaptor port:
controlport config
rcfc -ct point
-f
For each Fibre Channel
adaptor port:
controlport config rcfc
-ct point -f
2 “ showrctransport -rcfc showrctransport -rcfc
3 “ For each Fibre Channel
adaptor port:
controlport rcfc init
-f
For each Fibre Channel
adaptor port:
controlport rcfc init
-f
4 “ showrctransport -rcfc showrctransport -rcfc
NOTE: For N-to-1 Remote Copy, all Remote Copy pairs must share the same
secondary storage server.