B.15 – HP 3PAR Remote Copy Software User Manual
Page 151
B.15
controlport
InForm OS Version 2.3.1
Remote Copy User’s Guide
slot
Specifies the PCI bus slot in the specified node using a number from
0
to
6
.
port
Specifies the Fibre Channel adaptor port number of the PCI card in the specified PCI
bus slot using
1
to
4
.
Specifies the IP address for a Remote Copy interface.
Specifies the gateway address for a Remote Copy interface.
Specifies the netmask for a Remote Copy interface.
Specifies the MTU size for a Remote Copy interface using an integer from 100 through
9000. If no integer is specified, the value defaults to 1500.
Use only with the rcip speed subcommand. Specifies the speed setting (10, 100, or 1000)
and duplex setting (half or full) for a Remote Copy interface. In addition to this specifier,
you must also specify an interface using
specified, or if you specify auto with the
rcip speed
subcommand, the system auto-
negotiates the speed and duplex.
Specifies whether the port is used for a disk, host, or RCFC connection. This specifier must
be used when issuing the
config
command.
RESTRICTIONS
■
See the InForm OS Command Line Interface Reference for a complete list of restrictions.
■
The
controlport rcip addr
command is only allowed for node/slot/port combinations
where there is an interface installed.