HP 3PAR Remote Copy Software - Manual (Page 190)

B.54 showport
Remote Copy User’s Guide InForm OS Version 2.3.1
EXAMPLES
The following example displays information about all Remote Copy ports:
The columns in the previous example are identified as follows:
■ N:S:P . The physical position of the port, in the syntax node:slot:port .
■ State . State of the port.
◆ ready . The port is online and ready for use.
◆ loss_sync . The port is not physically connected to anything.
◆ config_wait . Firmware has yet to be initialized.
◆ login_wait . Fibre Channel adapter is attempting port and process logins with all loop
ports.
◆ error . Fibre Channel adapter has experienced an unrecoverable error.
◆ non_participate . Port is logically isolated from the Fibre Channel loop.
◆ offline . The port is offline.
■ HwAddr . A unique identifier of the port hardware used for Remote Copy connection. For an
RCIP port, it is the MAC address of the port.
■ Rate . Data transfer rate (bitrate) for the Remote Copy interface.
■ Type . Indicates the port connection type.
◆ rcip . Port is used for Remote Copy over IP (RCIP).
cli% showport –rc
N:S:P State HwAddr Rate Type
5:3:2 ready 25320002AC000006 2Gbps rcip
4:1:1 ready 24110002AC000006 2Gbps rcip
0:5:1 ready 0002B39B2013 100Mbps rcip