HP 3PAR Remote Copy Software - Manual (Page 191)

B.55 showport
InForm OS Version 2.3.1 Remote Copy User’s Guide
The following example displays information about RCIP ports:
The columns in the previous example are identified as follows:
■ N:S:P . The physical position of the port, in the syntax node:slot:port .
■ State . State of the port.
◆ ready . The port is online and ready for use.
◆ loss_sync . The port is not physically connected to anything.
◆ config_wait . Firmware has yet to be initialized.
◆ login_wait . Fibre Channel adapter is attempting port and process logins with all loop
ports.
◆ error . Fibre Channel adapter has experienced an unrecoverable error.
◆ non_participate . Port is logically isolated from the Fibre Channel loop.
◆ offline . The port is offline.
■ HwAddr . A unique identifier of the port hardware used for Remote Copy connection. For an
RCIP port, it is the MAC address of the port.
■ IPAddr . The IP address of the Remote Copy interface.
■ Netmask . Netmask for the Ethernet port.
■ Gateway . Gateway address for the Remote Copy interface.
■ MTU . Maximum Transfer Unit (MTU) size for the specified Remote Copy interface (default is
1500). The largest supported value is 9000 and the smallest is 100.
■ Rate . Data transfer rate for the Remote Copy interface.
■ Duplex . Values can be either Full or Half .
■ AutoNeg . Autonegotiate.
cli% showport -rcip
N:S:P State ---HwAddr--- IPAddr Netmask Gateway MTU Rate Duplex AutoNeg
0:1:1 offline 000423C21B72 - - - - n/a n/a n/a
0:1:1 offline 000423C21B73 - - - - n/a n/a n/a
1:2:1 offline 000423ADE95E - - - - n/a n/a n/a
1:2:1 offline 000423ADE95F - - - - n/a n/a n/a