B.12 – HP 3PAR Remote Copy Software User Manual
Page 148
B.12
controlport
Remote Copy User’s Guide
InForm OS Version 2.3.1
rcip mtu
Sets the Maximum Transfer Unit (MTU) size for the specified Remote Copy interface(s),
overriding the default of 1500. The largest supported value is 9000 and the smallest is 100.
Only for RCIP ports. Refer to
Specifiers
on page B.14 for parameters required to issue this
subcommand.
rcip state up|down
Sets the specified Remote Copy interface(s) as either up or down. Only for RCIP ports. Refer
to
Specifiers
on page B.14 for parameters required to issue this subcommand.
rcip speed
Sets the specified Remote Copy interface(s) to use the specified speed and duplex, or to
auto negotiate speed and duplex. The default is
auto
. Only for RCIP ports. Refer to
Specifiers
on page B.14 for parameters required to issue this subcommand.
rcip ping
Performs a ping from the specified interface to the specified address. Only for RCIP ports.
See
Specifiers
on page B.14 for parameters required to issue this subcommand. Use with
the
–pf
option to prevent fragmentation of packets (see
rcfc init
Initializes the Fibre Channel interface on the specified port. Refer to
Specifiers
on page B.14
for parameters required to issue this subcommand.
rcfc delete
Deletes the Fibre Channel interface on the specified port. Refer to
Specifiers
on page B.14
for parameters required to issue this subcommand.
intcoal
Enables or disables interrupt coalescing. The specified port will be reset.
OPTIONS
-m
This option can only be used with the rst subcommand. Resets the mode of the port. The
port can be reset to a target or initiator mode. If not specified, the port is reset to its
current mode. If the port's mode change value is prohibited, this command fails when
attempting to reset to a different mode. Use showport
-c
to see whether mode change is
allowed or prohibited for a particular port. See NOTES for additional information
regarding port pair protection. This option is deprecated and will be removed in a later
release. Use controlport config to set target (host) or initiator (disk) modes.