Ix.3 – HP 3PAR Remote Copy Software User Manual
Page 337
IX.3
InForm OS Version 2.3.1
Remote Copy User’s Guide
display
configuration details B.57
statistics for group B.74
documentation, related 1.2
double link failure 2.36
E
enable Remote Copy B.66
error handling 2.35
F
fail_wrt_on_err group policy 4.4
fail_wrt_on_err policy 2.37, 4.4
failures
active storage server 2.38
backup storage server 2.38
command failure due to no mirror config C.8,
complete network failure 2.36
double link 2.36
newtwork failure (disaster recovery) C.8, C.19,
primary storage server 2.38
read errors 2.39
read request failure 2.39
scenarios 2.35
single link 2.35
storage server 2.38
synchronization failure 2.39
volume group policies 4.4
write errors 2.38
fast resynchronization 2.27
Fibre Channel adaptor ports 3.13, 5.5
controlling B.9
full synchronization 2.25, 2.26, 2.31
fully provisioned virtual volume 2.42
fully provisioned virtual volume, converting
standard volumes to fully provisioned virtual
volumes 4.8
fully provisioned virtual volumes 2.22, 2.33
G
Gigabit Ethernet 3.8, 5.1
cards 2.41
interface 2.19, 3.8, 3.11
links 2.19
switches 2.19
group
add target to B.5
add virtual volume to B.7
create B.18
display statistics for B.74
remove B.31
remove virtual volume from B.27
turn on remove copy for B.67
group policies
auto_recover 4.5
fail_wrt_on_err 4.4
no_auto_recover 4.5
no_fail_wrt_on_err 4.4
growvv command B.29
H
host writes timing out 2.21
I
I/O statistics
ports B.69
identify primary and backup storage servers B.20
increasing server MTU 3.11
InForm CLI 1.1
initial synchronization 3.23
using tape backup 3.38
initiating
a synchronization 2.25
disaster recovery C.9, C.20, C.32
manual resynchronization 2.29, 4.5
install and configure controller node ports 3.8,
IP subnets 2.19, 3.3, 3.8
L
latency 2.18, 2.24
length of the synchronization period 2.28
limiting
the performance impact of Remote Copy 2.29,
throughput 2.30, 4.10
link