HP 3PAR Remote Copy Software - Manual (Page 230)

C.12 Bidirectional Synchronous Disaster Recovery Example
Remote Copy User’s Guide InForm OS Version 2.3.1
5 On the restored system (InServ1), issue the showrcopy command and verify that the
target displays ready, the sending links display Up, the volumes are Syncing, and the
group is displayed as -Rev as shown in bold in the following example:
After the synchronization is verified, restore the direction of each system.
On InServ1:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
InServ2 9 IP ready mirror_config
Link Information
Target Node Address Status Options
InServ2 0 10.100.33.11 Up
InServ2 1 10.101.33.11 Up
receive 0 10.100.33.11 Up
receive 1 10.101.33.11 Up
Group Information
Name Target Status Role Mode Options
sync_group_1 InServ2 Started Secondary-Rev Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
localvv.0 413 remotevv.0 375 Syncing Thu Dec 14 17:58:25 PST 2006
localvv.1 414 remotevv.1 376 Syncing Thu Dec 14 17:58:25 PST 2006
Name Target Status Role Mode Options
sync_group_2.r11 InServ2 Stopped Secondary Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
remotevv.0 423 localvv.0 385 Stopped Thu Dec 14 17:51:49 PST 2006
remotevv.1 424 localvv.1 386 Stopped Thu Dec 14 17:51:44 PST 2006
CAUTION: The group must be started at the time the setrcopygroup restore
command is issued. Issue the showrcopy groups command to
confirm the group has been started. If it has not been started then issue the
startrcopygroup command and wait for any synchronizations
that are started to complete before issuing the setrcopygroup restore
command.