HP 3PAR Remote Copy Software - Manual (Page 72)

3.10 Setting the Remote Copy Transport Layer
Remote Copy User’s Guide InForm OS Version 2.3.1
1 Use the following command to set the system gateways for the Ethernet ports on storage
server:
In order to issue this command on a storage server, you will need the gateway IP address to
assign to the local Ethernet port ( ) and the location of a local Ethernet port
( ).
2 For each storage server in the Remote Copy configuration, verify that the gateways have
been set correctly by checking the Gateway column in the showport -rcip command
output:
3.4.2.2 Verifying Connectivity
After you have set the Remote Copy interfaces between the two storage servers by configuring
the GigE ports, verify connectivity from any storage server as follows:
# controlport rcip gw
Are you sure you want to change the gateway for ?
select q=quit y=yes n=no: y
Remote Copy interface change successful.
NOTE: Remember to set the interfaces for both ports on each storage server to be
used in the Remote Copy configuration.
# showport -rcip
N:S:P State ---HwAddr--- IPAddr Netmask Gateway MTU
Rate Duplex AutoNeg
0:3:1 ready 000423CBF68C 10.100.24.107 255.255.255.0 10.100.24.1 1500
1Gbps Full Yes
1:3:1 ready 000423CBF693 10.101.24.107 255.255.255.0 10.101.24.1 1500
1Gbps Full Yes
# controlport rcip ping 10.101.24.108 0:3:1
PING 10.101.24.108 (10.101.24.108) from 10.100.24.107 : 56(84) bytes of
data.
64 bytes from 10.101.24.108: icmp_seq=1 ttl=253 time=0.325 ms
--- 10.101.24.108 ping statistics ---
1 packets transmitted, 1 received, 0% packet loss, time 0ms
rtt min/avg/max/mdev = 0.325/0.325/0.325/0.000 ms