HP 3PAR Remote Copy Software - Manual (Page 228)

C.10 Bidirectional Synchronous Disaster Recovery Example
Remote Copy User’s Guide InForm OS Version 2.3.1
2 On the failover system, verify the reversal by using the showrcopy command and checking
that the Role for the group is now Primary-Rev, as shown in bold in the following
example:
3 After the remote system (InServ1) has been restored and the target is ready, issue the
setrcopygroup recover command on the failover system to resynchronize the servers.
On InServ2:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
InServ1 2 IP failed mirror_config
Link Information
Target Node Address Status Options
InServ1 0 10.100.33.96 Down
InServ1 1 10.101.33.96 Down
receive 0 10.100.33.96 Up
receive 1 10.101.33.96 Up
Group Information
Name Target Status Role Mode Options
sync_group_1.r96 InServ1 Stopped Primary-Rev Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
remotevv.0 375 localvv.0 413 Stopped Thu Dec 14 17:50:53 PST 2006
remotevv.1 376 localvv.1 414 Stopped Thu Dec 14 17:50:52 PST 2006
Name Target Status Role Mode Options
sync_group_2 InServ1 Stopped Primary Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
localvv.0 385 remotevv.0 423 Stopped Thu Dec 14 17:51:48 PST 2006
localvv.1 386 remotevv.1 424 Stopped Thu Dec 14 17:51:44 PST 2006
On InServ2:
# setropygroup recover -t InServ1