HP 3PAR Remote Copy Software - Manual (Page 117)

4.11 Stopping Remote Copy
InForm OS Version 2.3.1 Remote Copy User’s Guide
4.10 Stopping Remote Copy
` If you want to stop using Remote Copy, issue the stoprcopy command as follows:
` To stop using Remote Copy functionality on all volume groups, delete all Remote Copy
configuration data, and release all resources used by Remote Copy, add the -clear option
to the stoprcopy command as follows:
Without the -clear argument, this command only stops the Remote Copy. You can restart
that copy later using the startrcopy command.
4.11 Remote Copy Commands
Table 4-2 contains a list of tasks and their associated commands. Enter Remote Copy
commands using the InForm CLI. Refer to the InForm OS Command Line Interface Reference
for detailed instructions on using the CLI. For details about each command, refer to
Appendix B, Remote Copy Commands .
# stoprcopy -stopgroups
# stoprcopy -stopgroups -clear
NOTE: See Remote Copy and Thin Provisioning on page 2.33 for important
information about space allocation and deleted snapshots.
NOTE: When issuing commands that are mirrored from one system to the other,
there is a five minute timeout limit. After five minutes, if the other system does
not respond to a command, the following error message appears:
target system could not be contacted