HP 3PAR Remote Copy Software - Manual (Page 147)

B.11 controlport
InForm OS Version 2.3.1 Remote Copy User’s Guide
cl2
Specifies the Fibre Channel Class-2 parameter of the port. The specified port will be reset.
Note that this option is deprecated and will be removed in a subsequent release.
rate
Specifies the data rate of the Fibre Channel port. The specified port will be reset.
vcn
Sets the VLUN Change Notification (VCN) generation support (enable or disable). When
VCN generation support is enabled with a public loop or fabric topology, a Registered State
Change Notification (RSCN) message is issued to the fabric controller whenever a VLUN is
created or removed. In addition, if enabled with a public loop topology, a Loop
Initialization (LIP) is issued from the port whenever a VLUN is created or removed.
persona
Port personas have been removed and this command no longer sets them. As port
personas have been replaced by host personas, this command will print the host persona
commands to use instead. See createhost and sethost for setting host personas and
controlport config for setting port parameters.
nssync
Verifies current port database against the Name Server when a fabric is attached. Entries
present in the database but missing from the Name Server are removed. Using this
command is not required under normal circumstances.
rcip addr
Sets the Remote Copy interface to use the specified IP address and netmask. Refer to
Specifiers on page B.14 for parameters required to issue this subcommand.
rcip gw
Sets the gateway for one or more Remote Copy interfaces. Only for RCIP ports. Refer to
Specifiers on page B.14 for parameters required to issue this subcommand.
rcip delete
Deletes the configuration for one or more specified Remote Copy interfaces. Refer to
Specifiers on page B.14 for parameters required to issue this subcommand.