HP 3PAR Remote Copy Software - Manual (Page 181)

B.45 setrcopytarget
InForm OS Version 2.3.1 Remote Copy User’s Guide
The measured bandwidth of the connection to the target, specified in kilobytes (kB) per
second. This specifier can only be used with the tunelinks subcommand.
The measured round-trip latency of the connection to the target, specified in milliseconds
(ms). This specifier can only be used with the tunelinks subcommand.
RESTRICTIONS
■ This command requires the 3PAR Remote Copy license. Contact your local service provider
for further information.
■ If the mirror_config policy is set and the setrcopytarget command is issued with the
pol subcommand, the duplicated configuration commands cannot be issued on the
secondary. Doing so results in an error.
■ The name and tput subcommands cannot be used on a target with started groups.
■ There must be an active connection between the systems in the Remote Copy pair in order
to issue commands on the primary server to be mirrored to the backup server. If there is no
connection, the commands will return an error.
EXAMPLES
The following example turns off configuration mirroring from InServ1 to InServ2 , where
InServ2_out is a secondary target on InServ1 that points at InServ2 :
NOTES
■ The setrcopytarget command requires the groups associated with it be stopped prior to
using the following options:
◆ setrcopytarget name
◆ setrcopytarget tput
■ The setrcopytarget command with the following arguments can be run without
bringing down its Remote Copy groups:
◆ setrcopytarget pol
On InServ1:
cli% setrcopytarget pol no_mirror_config InServ2_out