beautypg.com

3 mes-2110 configuration and console – ZyXEL Communications MES-2110 User Manual

Page 211

background image

Chapter 24 Troubleshooting

MES-2110 User’s Guide

211

24.3 MES-2110 Configuration and Console

I’m trying to configure MVR but I get an error message.

MVR only functions with Tag-Based (802.1q) VLANs. To rectify this:

• Open the Configuration > VLAN Menu > VLAN Type screen and set the

VLAN Type option to Tag-Based (802.1q).

Or

• Connect to the MES-2110 through the console port (

Chapter 23 on page 179

)

and enter the following commands:

.

I applied changes in the Web Configurator but they are not taking effect.

• Makes sure that you saved all configuration changes using the Save Settings

link in the Web Configurator’s navigation pane.

• Clean out the cache of the browser that you are using to connect to the MES-

2110’s Web Configurator, and make sure that you’re only using a browser

supported by the device (

Chapter 1 on page 19

)

• Try making your changes through the MES-2110’s command line interface

(

Chapter 23 on page 179

), and using the write memory command to make the

changes permanent.

• Power off the MES-2110, then power it back on and make your changes afresh.
• Reset the MES-2110 to its factory default settings (

Section 5.6 on page 59

).

• If the problem continues, contact the vendor.

MES-2110: enable

MES-2110# configure terminal

MES-2110(config)# vlan-type 802.1q