ZyXEL Communications MES-2110 User Manual
Page 192
Chapter 23 Command Line Interface
MES-2110 User’s Guide
192
qos ip-dscp-pri-queue <0~63>
Sets the QoS IP IP-DSCP Priority to queue
mapping. The default is low.
qos tag-pri-queue <0-7>
Set the QoS tag priority to queue mapping.
rmon clear
Clears the RMON information for ports 1~10.
snmp contact
Sets the SNMP system contact name.
contact-name
: Enter up to 80 characters.
snmp getcommunity
Sets the SNMP GET community.
community-name
: Enter up to 30 characters.
Note: Only for SNMP v2c or lower.
snmp location
Sets the SNMP system location.
location-name
: Enter up to 80 characters.
snmp setcommunity
Sets the SNMP SET community.
community-name
: Enter up to 30 characters.
Note: Only for SNMP v2c or lower.
snmp trapcommunity string> Sets the SNMP trap community. index : Enter an index number (1~5). community-string : Enter up to 30 characters. snmp trapenable Enables the SNMP trap. index : Enter an index number (1~5). snmp trapip Sets the IP addresses of up to 5 SNMP index : Enter an index number (1~5). sntp Enables and disables SNTP support. sntp-NTP-primary-server Set SNTP primary server's IP address. sntp-NTP-secondary-server Set SNTP secondary server's IP address. sntp poll_interval Sets the interval in specified hours between sntp time Sets the local time by year (yyyy), month (mm), sntp timezone <+hh.mm | -hh.mm> Sets the timezone offset. +hh.mm : Increases the timezone offset by the specified hours (hh) and minutes (mm). -hh.mm : Increases the timezone offset by the specified hours (hh) and minutes (mm). Table 80 Configuration Mode Commands COMMAND DESCRIPTION
managers to receive SNMP traps.
SNTP requests.
day (dd), hour (hh), minutes (mm), and
seconds (ss).