ZyXEL Communications MES-2110 - Manual (Page 168)

Chapter 22 Mgmt Config and System Restart Menu
MES-2110 User’s Guide
168
managers. Use this screen to configure the trap manager settings. Click Mgmt
Config > SNMP Config > IP Trap Manager to open the following screen.
Figure 83 Mgmt Config > SNMP Config > IP Trap Manager
The following table describes the labels in this screen.
22.4 The SNTP Screen
Use this screen to configure the time settings on the MES-2110. You can configure
the MES-2110 to get the time and date information from a time server using
Simple Network Time Protocol (SNTP). You can also configure two servers. If the
first one is down, the MES-2110 will try to connect to the second one.
Table 67 Mgmt Config > SNMP Config > IP Trap Manager
LABEL DESCRIPTION
IP Address Enter the IP addresses of up to five managers to send your SNMP
traps to.
Community Name Enter the community string.
Status Use this to enable or disable the trap manager feature.
Undo Click this to restore your last saved settings.
Apply Click Apply to save your changes to the ZyXEL Device’s run-time
memory. The ZyXEL Device loses these changes if it is turned off
or loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory.