beautypg.com

9 vlan mode – ZyXEL Communications MES-2110 User Manual

Page 197

background image

Chapter 23 Command Line Interface

MES-2110 User’s Guide

197

23.9 VLAN Mode

This is an ancillary mode of Configuration mode. You must be in Configuration
mode for these commands to work.

When in VLAN-Configuration mode, the command prompt is as follows:

.

The following is a list of available VLAN-Configuration mode commands:

Note: These commands only apply to the VLAN ID specified when you enter VLAN

Configuration mode.

MES-2110(config-vlan)#

Table 82 VLAN Mode Commands

COMMAND

DESCRIPTION

vlan <1-4094>

Enters VLAN Configuration mode for the
specified VLAN ID. If no VLAN IDs exist, then
this creates the specified ID.

manage

Sets the current VLAN as a management VLAN.

member

Specifies the ports that are members of the
current VLAN group.

non-member

Specifies the ports that are excluded from the
current VLAN group.

tagging

Specifies the ports in the current VLAN group for
which you want outgoing frames tagged.

untagging

Specifies the ports in the current VLAN group for
which you do not want outgoing frames tagged.

use-vid-priority

Select yes to enable VID priority for the current
VLAN group, or

no

to disable it.

vid-priority <0~7>

Sets the VID priority (0~7).