ZyXEL Communications MES-2110 - Manual (Page 106)

Chapter 12 VLAN
MES-2110 User’s Guide
106
SPVID SPVID is the service provider’s VLAN ID (the outer VLAN tag).
Enter the service provider ID (from 1 to 4094) for frames received
on this port.
Priority On the MES-2110, configure priority level of inner IEEE 802.1Q
tag in the Configuration > QoS Menu > 802.1p Priority
screen.
"0" is the lowest priority level and "7" is the highest.
Undo Click this to restore your last saved settings.
Apply Click Apply to save your changes to the MES-2110’s run-time
memory. The MES-2110 loses these changes if it is turned off or
loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory when you
are done configuring.
VLAN Stacking Status
Port1-10
This is the port number.
Active This shows whether VLAN stacking is enabled or disabled on the
MES-2110.
SP TPID This is the service provider VLAN tag.
Role This shows how the port process transmitted frames.
SPVID This is the service provider ID for frames received on this port.
Priority This shows the priority level of frames transmitted through the
port.
Table 34 Configuration > VLAN Menu > Tag-Based > VLAN Stacking
LABEL DESCRIPTION