ZyXEL Communications MES-2110 - Manual (Page 183)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
183
23.6 Privileged Command Mode
When in Privileged mode, the command prompt is as follows:
.
The following is a list of Privileged mode commands:
MES-2110#
Table 78 Privileged Commands
COMMAND DESCRIPTION
enable
Turns on Privileged mode commands.
disable
Turns off Privileged mode commands, returning
the device to Basic mode.
copy config tftp
Uploads a configuration file from the specified
TFTP server’s IP address.
copy firmware tftp
name>
Uploads a firmware file from the specified TFTP
server’s IP address.
copy syslog tftp
Uploads a syslog file from the specified TFTP
server’s IP address.
copy tftp command-text
name>
Downloads a command file from the specified
TFTP server’s IP address.
copy tftp config
Downloads a configuration filefrom the specified
TFTP server’s IP address.
copy tftp firmware
file-name>
Downloads a firmware file from the specified
TFTP server’s IP address.
reset default
Resets the device to its factory default settings.
reset system
Resets the system.
show abnormal
Displays the abnormal traffic detection
configuration.
show arp inspection
Displays ARP inspection information.
config
: Displays the ARP inspection
configuration file.
status
: Displays the ARP inspection records.
show bandwidth-control
Diplays the bandwidth control information.
show cable
Displays the cable test results. Select all to view
all test result or test by a specific port number.
show 8021p-priority
Displays the 8021p priority configuration for all
ports.
show console-baudrate
Displays the baud rate of the console port.
show console-timeout
Displays the number of idle seconds allowed on
the console port before the device automatically
terminates the session.
show dhcp smart-relay
Displays DHCP smart relay information.
show dhcp snooping
Displays DHCP snooping information.