ZyXEL Communications MES-2110 - Manual (Page 201)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
201
no multicast-limit
Disables the multicast packet limit for the
current port(s).
no dlf-limit
Disables the DLF packet limit for the current
port(s).
no dot1x port-control
Disables port control of 802.1x for the current
port(s).
no dot1x guest-vlan
Disables guest VLAN for the current port(s).
no dot1x reauth
Disables reauthentication of 802.1x for the
current port(s).
8021p-priority <0-7>
Sets default ingress priority to use when no
priority information avilable for the current
port(s).
pvid <1-4094>
Sets the PVID for the current port(s).
qos-priority-mode
Sets the QoS priority mode for the current
port(s).
default
: Port Priority.
tag
: IEEE Tagged Frame Priority.
ip
: IPv4 and IPv6 Frame Priority.
ip&tag
: IPv4 and IPv6 with IEEE Tagged Frame
Priority.
qos-ipdscp-over-tag
Sets the QoS ipdscp over tag priority for the
current port(s).
dot1x reauth-period <1-999999>
Set reauthentication period for the current
port(s). The default is 3600.
dot1x enable
Enable 802.1x port control for the current
port(s).
dot1x reauth enable
Enable 802.1x reauthentication for the current
port(s).
dot1x guest-vlan enable
Enables guest VLAN for the current port(s).
rstp-edge
Sets the RSTP port edge for the current port(s).
rstp-p2p
Sets the RSTP port point-to-point (p2p) option
for the current port(s).
rstp-path-cost <0-65535>
Sets the RSTP port path cost for the current
port(s). The default is 1000M=4, 100M=19.
rstp-priority <0-255>
Sets the RSTP port priority for the current
port(s). The default is 128.
sa-pri-override
Sets the source MAC priority override for the
current port(s).
speed-duplex <10f|10h|100f|100h|1000f>
Sets the duplex and speed mode for the current
port(s).
sfp-speed <100|1000|1000-no-auto>
Sets the SFP fiber speed for the current port(s).
Table 83 Interface Mode Commands
COMMAND DESCRIPTION