ZyXEL Communications MES-2110 - Manual (Page 189)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
189
erase-mac-table
Erases all dynamic MAC entries from the MAC
table.
frame-size <1522|1632>
Sets the frame size. The default is 1632.
gateway
Sets the gateway IP address.
hdos ip
Sets the acceptable IP address for Host Denial
of Service (DoS) protection.
index :
Enter an index number (1-5).
ip-address
: Enter an IP address to associate
with an index number.
hdos ip-enable
Enables or disables an individual IP address for
Host Denial of Service (DoS) protection.
index :
Enter an index number (1-5).
enable|disable
: Enable or disable the IP
address associated with this index number.
hdos protection
Enables or disables the Host Denial of Service
(DoS) protection service.
igmp immediate-leave
Sets the port list for IGMP immediate-leave.
igmp query-mode
Sets the IGMP query mode.
igmp snooping
Enables IGMP snooping.
igmp static
Sets the IGMP static port list.
igmp vlan <1-4094>
Specifies the VLANs on which to perform IGMP
snooping if the mode is fixed.
igmp vlan-mode
Specifies how the VLANs snooped by the device
select IGMP packets.
auto
: The device learns multicast group
membership on any VLAN. It drops a.ny IGMP
control messages on other VLANs after it
reaches this maximum number (auto mode).
fixed
: The device only learns multicast group
membership on specified VLAN(s). It drops any
IGMP control messages for any unspecified
VLANs (fixed mode).
igmp vlan-query-mode
Specifies the query mode for the specified VLAN.
ip
Sets the IP address of the device to the one
specified.
lacp group
Sets the specified trunk group to LACP or static.
lacp hash-mode
Sets the hash mode for trunk load balancing
selection.
xor
: Select this XOR the lower 3 bits of the DA
and SA frames together.
lookup
: Select this to use the lookup table.
Table 80 Configuration Mode Commands
COMMAND DESCRIPTION