7 configuration mode – ZyXEL Communications MES-2110 User Manual
Page 186

Chapter 23 Command Line Interface
MES-2110 User’s Guide
186
23.7 Configuration Mode
When in Configuration mode, the command prompt is as follows:
.
There are 3 additional ancillary available while in Configuration mode. They are:
The following is a list of baseline Configuration mode commands:
MES-2110(config)#
Table 79 Basic Commands
ANCILLARY
TRIGGER
DESCRIPTION
MVR
While in Configuration mode:
Type mvr <1-4094> (where 1-4094)
is the MVR ID ranging from 1 to
4094) at the command line prompt
and then press
[ENTER]
.
If no MVR exists, then this creates
one for you.
This mode allows to configure the MES-2110’s
MVR IDs and their associated options.
See
for details.
VLAN
While in Configuration mode:
Type vlan <1-4094> (where 1-4094
is a VLAN ID ranging from 1 to 4094)
at the command line prompt and
then press
[ENTER].
If no VLAN ID exists, then this
creates one for you.
This mode allows you to configure the MES-
2110’s VLAN IDs and their associated options.
See
for details.
Interface
While in Configuration mode:
Type interface
is a port number) at the command
line prompt and then press
[ENTER]
This mode allows you to configure the MES-
2110’s port interfaces and their associated
options.
See
for details.
Table 80 Configuration Mode Commands
COMMAND
DESCRIPTION
configure terminal
Toggles the Configuration mode, but only if you
are first in Privileged mode.
abnormal detection
Enables or disables abnormal traffic detection.
abnormal duration <1-60>
Sets the abnormal traffic detection duration in
seconds (1-60).
abnormal interval <1-600>
Sets the protection interval in seconds (1-600).
abnormal permanently
Blocks any port permanently when abnormal
traffic is detected and this option is set to
yes
.
abnormal threshold <2000-20000>
Sets the threshold of traffic detection in packets
per second (2000-20,000).