ZyXEL Communications MES-2110 User Manual
Page 187
Chapter 23 Command Line Interface
MES-2110 User’s Guide
187
arp inspection enable
Enables ARP inspection.
Note: You must still enable ARP inspection
on specific VLAN and specify trusted
ports if you use this option.
arp inspection vlan <1-4094>
Sets the ARP inspection VLAN ID.
arp inspection vlan-mode
Sets the ARP inspection VLAN mode.
arp inspection mac-filter-aging <0-10080>
Specifies how long (in minutes) MAC address
filters remain in the device after it identifies an
unauthorized ARP packet.
The device automatically deletes the MAC
address filter afterwards. Use ‘0’ in the
parameter field to make it permanent.
console-baudrate <9600|19200|38400>
Sets the console port’s baudrate.
console-timeout <0|10~3600>
Sets the console timeout in seconds.
0
: Sets the console to never timeout
10~3600
: Sets the console timeout in seconds
(minimum 10 seconds, maximum 3600 seconds,
default 300 seconds.)
dhcp binding
Adds the specified MAC address, IP address,
port numer, and VLAN ID to the DHCP snooping
static binding table.
dhcp client
Enables DHCP client.
dhcp option-information
Sets the DHCP Option Remote ID.
remote-id
: Enter a maximum of 64
characters.
dhcp smart-relay enable
Enables DHCP smart relay.
dhcp smart-relay exlude-vlan <1-4094>
Sets the DHCP smart relay to exlude the
specified VLAN.
dhcp smart-relay helper-address address> Sets the IP address of the DHCP server. ip-address : Enter the IP address of the remote server. dhcp smart-relay option Allows the device to add DHCP relay agent dhcp snooping enable Enables DHCP snooping. dhcp snooping vlan <1-4094> Sets the DHCP snooping VLAN ID. dhcp snooping vlan-mode Sets the DHCP snooping VLAN mode. all : Enter this to have the device enable DHCP snooping on all VLANs dynamically. fixed : Enter this to specify which VLANS can be enabled with DHCP snooping. dhcp snooping option Allows the device to add the DHCP option. Table 80 Configuration Mode Commands COMMAND DESCRIPTION
information.