ZyXEL Communications MES-2110 - Manual (Page 181)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
181
23.3 Logging Out
Enter exit to log out of the CLI while in Basic mode.
23.4 Command Modes
The MES-2110 segregates commands by command mode. Commands for a
particular mode are only available once you set the device to that particular mode.
The following is list of available command modes.
Table 75 Exit Command
COMMAND DESCRIPTION
exit
Logs you out of the CLI while in Basic mode. If
in any other mode, then this command returns
you to the previous mode.
Table 76 Basic Commands
MODE TRIGGER DESCRIPTION
Basic Log in. This is the default command line interface
mode when you log into the device.
Commands are restricted in this mode.
See Section 23.5 on page 182 for details.
Privileged While in Basic mode, type enable at
the prompt and then press
[ENTER]
.
This mode a limited command set for
configuring some of the MES-2110’s features.
See Section 23.6 on page 183 for details.
Configuration While in Privileged mode:
Type configure terminal at the
prompt and then press
[ENTER]
.
This mode allows to you configure all of the
MES-2110’s advanced options.
Configuration mode also has 3 ancillary
modes: MVR, VLAN, and Interface.
See Section 23.7 on page 186 for details.