ZyXEL Communications MES-2110 User Manual
Page 188

Chapter 23 Command Line Interface
MES-2110 User’s Guide
188
dot1x enable
Enables 802.1x on the device.
dot1x reauth-max <1~10>
Sets the maximum number of times re-
authentication can be used (1~10). The default
is 2 times. This kind of authentication method is
port-based.
dot1x guest-vlan <1-4094>
Sets the VLAN ID of the guest VLAN. This must
be an existing VLAN.
dot1x radius-server server-ip
Sets the RADIUS server’s IP address.
dot1x radius-server shared-secret
Sets the password for RADIUS server access.
string
: Enter a maximum of 29 characters.
dot1x radius-server server-udp-port <1-
65535>
Sets the UDP port number of the RADIUS server.
The default is 1812.
dot1x radius-server accounting-port <1-
65535>
Sets the accounting port of the RADIUS server.
The default is 1813.
dot1x radius-server timeout <1-300>
Sets the timeout period of the RADIUS server.
The default is 30.
email-alarm disable
Disables the email alarm. This is the default.
email-alarm enable
Enables the email alarm.
email-alarm from
Sets the email alarm’s “from” field to the
specified string.
string
: Enter up to 63 characters.
cr
: Leave this blank and press the [Enter] key
to clear the email-alarm from setting.
email-alarm server
Sets the email alarm’s server to the specified IP
address.
email-alarm to [
Sets the email alarm’s “to” field.
id
: Enter an ID number for this recipent (1~5).
If you enter just the ID and no other paramters
(
string
or
enable|disable
), then this
setting is cleared for that ID.
string
: Enter the recipient’s email address.
enable|disable
: Select whether to enable
this recipient or disable it. When disabled, no
alarm emails are sent to that recipient.
email-alarm type
p|gigedown|confchange|newroot1d|topochange 1d|arpinspectionover> Sets the email alarm type. When one of these For example: email-alarm type coldstart enable . This enables it for the coldstart event. If you want to also enable it for the warmstart email-alarm type warmstart enable . Table 80 Configuration Mode Commands COMMAND DESCRIPTION
events occurs and you have enabled that email
alarm type, the device sends out an alarm
email. You must configure each event
individually.
event, you must configure it separately: