ZyXEL Communications MES-2110 User Manual
Page 191
Chapter 23 Command Line Interface
MES-2110 User’s Guide
191
no dhcp smart-relay option
Disables the DHCP smart relay option.
no dhcp smart-relay vlan
Sets the DHCP smart relay to exclude VLANs.
cr
: Leave this field blank and press [Enter] to
use the default setting.
range
: Specify a range of VLAN IDs.
no dhcp snooping enable
Disables DHCP snooping.
no dhcp smart-relay exlude-vlan <1-4094>
Sets the DHCP smart relay to include the
previously excluded specified VLAN.
no dhcp snooping option
Disables the DHCP snooping option.
no dhcp snooping vlan <1-4094>
Disables the specified DHCP snooping VLAN ID.
no dot1x global
Stops 802.1x running globally
no dot1x guest-vlan
Disables Guest VLAN.
no gateway
Sets the device’s default gateway.
no igmp immediate-leave
Sets IGMP fast leave to its default value.
no igmp query-mode
Sets IGMP query mode to its default type for the
specified VLAN ID.
no igmp snooping
Disables IGMP snooping.
no igmp static
Disables the IGMP static port.
no igmp vlan <1-4094>
Disables IGMP VLAN for the specified VLAN ID.
no ip
Sets the device to its default IP address.
Note: You cannot change the device’s IP
address over Telnet.
no lacp
Disables LACP.
no logins
Resets the login password to NULL.
no mvr <1-4094>
Removes an MVR configuration from the
specified VLAN.
no netmask
Sets the default netmask.
no spanning-tree
Disables the spanning tree.
no trunk
Disables the trunk group.
no vlan <2-4094>
Deletes the static VLAN entry.
no vlan-stacking
Disables VLAN stacking.
qinq-sp-tpid
Sets the SP TPID. SP TPID is a standard
Ethernet type code identifying the frame and
indicating whether the frame carries IEEE
802.1Q tag information.
tpid
: Enter the Server Provider Tag Protocol
Identifier. This can be a four-digit hexadecimal
number from 0000 to ffff. The default is 9100.
qos schedule all_high_before_low
Sets the QoS schedule to all high before low.
qos schedule weighted_round_robin
Sets the QoS to weighted round_robin.
Table 80 Configuration Mode Commands
COMMAND
DESCRIPTION