ZyXEL Communications MES-2110 - Manual (Page 185)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
185
show rstp
Displays the RSTP configuration.
show sfp ddmi port
Displays the SFP fiber port DDMI information for
the specified port.
show sfp serial-no port
Displays the SFP serial number for the specified
port.
show sfp vendor port
Displays the SFP vendor name for the specified
port.
show snmp
Displays the snmp configuration.
show sntp
Displays the SNTP configurations.
show sntp-timezone
Displays a list of time zones and their GMT offset.
show storm-control
Displays the storm control configuration.
show syslog []
Displays all syslog messages.
You can also specify a range of syslog messages.
begin
: Enter the first syslog message to display.
end
: Enter the last syslog message to display.
show syslog-config
Displays the syslog configuration.
show version
Displays the system version.
show vlan port-base
Displays the port-base VLAN.
show vlan stacking
Displays the VLAN stacking status.
show vlan tag-base management-VLAN
Displays the VLAN for the management switch.
show vlan tag-base vlan-id
Displays the tag-base VLAN ID.
show vlan tag-base port-info
Displays the tag-base port information.
show vlan tag-base vlan-table
Displays tag-base VLAN table.
show vlan type
Displays the VLAN type.
write memory
Saves the current configuration, including all
changes made since the last save, to flash.
Note: You must use this command to
permanently save any changes you
make while using the MES-2110
command line interface.
Table 78 Privileged Commands
COMMAND DESCRIPTION