Roland RK-300 - Manual (Page 67)

67
Performing
Modifying the Sound
You can modify the sound simply by moving your hand above the D Beam controller located on the
panel.
fig.P-DBeam.eps
1.
Press a D BEAM button, [PITCH], [FILTER], or [VOLUME], a number of times until
the button is lit red.
2. Move your hand above the D Beam controller.
The sounds you play from the keyboard will change as you move your hand above the D Beam
controller.
The sensitivity of the D Beam controller will vary according to the brightness of its
surroundings. If it does not operate as you expect, you can readjust the sensitivity.
Increasing the D Beam sensitivity value (p. 171) will make it more sensitive.
3.
To turn off the D Beam controller, press the button that’s lit enough times to
turn off its illumination.
Using the D Beam Controller for Additional Enjoyment
Button Button status Explanation
[PITCH]
Lit red
Changes the pitch of the sounds you play on the keyboard.
[FILTER]
Changes the tonal character of the sounds you play on the keyboard.
* For some sounds, the tonal change may be difficult to notice.
[VOLUME] Changes the volume of the sounds you play on the keyboard.
Effective range of the D Beam controller
The illustration at right shows the effective range of the D Beam
controller.
Moving your hand outside this range will not produce any effect.
The effective range of the D Beam controller will be drastically
decreased under strong direct sunlight. Please be aware of this when
using the D Beam controller outdoors.
RK-300_e.book 67 ページ ２００８年９月１０日 水曜日 午後４時６分