Roland RK-300 - Manual (Page 38)

38
Getting Ready
You can use headphones to enjoy the RK-300 without disturbing those around you, such as at night. Since the RK-300 has two
headphone jacks, two people can also use headphones simultaneously.
If you’re using only one set of headphones, you may connect them to either of the two headphone jacks.
0_fig.Headphones-a.eps
1.
Plug the headphones into the Phones jack.
If headphones are connected, no sound will be output from
the RK-300’s speakers.
2.
Use the RK-300’s [VOLUME] knob (p. 34) to adjust
the headphone volume.
• To prevent damage to the cord’s internal conductors,
avoid rough handling. When using headphones, mainly
try to handle either the plug or the headset.
• Your headphones may be damaged if the volume of a
device is already turned up when you plug them in.
Minimize the volume before you plug in the headphones.
• Excessive input will not only damage your hearing, but
may also strain the headphones. Please enjoy music at an
appropriate volume.
• Use headphones that have a stereo 1/4” phone plug.
Whenever you are not using the headphones, you can hang
them on the headphone hook of the RK-300.
0_fig.headphonHook.eps
1.
Press and twist the headphone hook included with
the RK-300 into the hole in the bottom left of the
RK-300 (refer to the figure above).
2.
Turn the headphone hook wing nut to secure the
headphone hook.
• Do not hang anything other than headphones on the
headphone hook. Doing so may damage the instrument
or the hook.
Listening Through Headphones
Attaching the Headphone Hook
Wing nut
Headhone
hook
RK-300_e.book 38 ページ ２００８年９月１０日 水曜日 午後４時６分