Roland RK-300 - Manual (Page 27)

27
Getting Ready
Installing the RK-300 on the KSC-48
4.
Set the RK-300 on the KSC-48, then firmly attach
the four knob bolts.
* When handling the RK-300, firmly grasp it. Be careful, so you
do not get your fingers pinched.
Please don’t
get your fingers
pinched
If Using the KS-G8 Stand
Front (keyboard) side
Rear panel side
Top View
(A) (A)
(B)
(B)
Place the RK-300 so that the rubber feet closest to its rear panel
are directly above the arms at locations (A) and also located at
both sides of the rubber feet of the arms.
Make sure that the screws located on the bottom of the RK-300
at locations (B) are not resting on the arm’s rubber foot.
RK-300_e.book 27 ページ ２００８年９月１０日 水曜日 午後４時６分