Roland RK-300 - Manual (Page 26)

26
Getting Ready
Do not grasp the jack panel cover when lifting the RK-300
keyboard unit.
fig.JackCoverCaution.eps
If you need to transport the RK-300 keyboard unit, remove
the jack panel cover, and hold the bottom of the unit when
lifting it.
fig.JackCoverRemove.eps
If you place the RK-300 on a stand, you must use the special stand KSC-48 (sold separately) or KS-G8 (sold separately).
When placing the RK-300 on the KSC-48 or KS-G8, place it in the position shown below.
Using the RK-300 with any other stand may produce an unstable situation, possibly causing the instrument to fall or overturn, and
resulting in injury or damage.
For details on how to assemble the stand, refer to the owner's manual that accompanied the stand.
Stand Assembly
At first, assemble the entire stand in a temporary fashion,
without really tightening the screws. Then, after checking
the overall alignment of the boards (and gently shifting
certain parts where necessary), go around and tightly fasten
each of the screws.
1.
Attach the side board (right) for the right sides to
the speaker box.
Use screws to temporarily fasten these parts together.
2.
Attach the side board (left) for the left sides to the
speaker box.
Use screws to temporarily fasten these parts together.
3.
After you’ve temporarily fastened the screws, place
the stand upright, and securely tighten screws to
fasten the speaker box and side boards.
CAUTION
Jack panel cover
Loosen
Loosen
Grasp
here
Placing the RK-300 on a Stand
If Using the KSC-48 Stand
RK-300_e.book 26 ページ ２００８年９月１０日 水曜日 午後４時６分