Roland RK-300 - Manual (Page 39)

39
Getting Ready
You can’t use the VIDEO OUTPUT jack and ANALOG RGB OUT connector at the same time.
fig.ConnectTV.eps
Before you make connections to other devices, you must
turn down the volume of all devices and turn off their power
to prevent malfunctions or damage to your speakers.
1.
Switch off the RK-300 and the television you’ll be
connecting (p. 33).
2.
Connect the RK-300 to your television, use a video
cable (commercially available) to connect the RK-
300’s VIDEO OUTPUT jack to the television.
3.
Switch on the RK-300 (p. 33).
4.
Switch on your television.
5.
Set to “Video” at “Selecting the Video Output
Destination” (p. 40).
6.
(As necessary) Specify the television output format
(p. 175).
7.
Specify the aspect ratio (ratio between width and
height) for your television (p. 176).
• The aspect ratio is the proportional relationship between
the width and height of the screen. The RK-300’s screen
has an aspect ratio of 16:9. Televisions can have an aspect
ratio of either 4:3 or 16:9 (wide screen).
• There are small areas at the left and right of the screen
that do not show an image; this is due to the design of
the RK-300.
fig.ConnectDisplay.eps
Types of display that can be connected
In general, you can connect any display that is sold as a
“multiscan monitor.” However, to be certain, please check
the following specifications before you connect your display.
Before you make connections to other devices, you must
turn down the volume of all devices and turn off the power
to prevent malfunctions or damage to your speakers.
1.
Switch off the RK-300 and the display you’ll be
connecting (p. 33).
2.
Use a commercially available monitor cable to
connect the RK-300’s ANALOG RGB OUT connector
to the analog RGB connector of your display.
3.
Switch on the RK-300 (p. 33).
4.
Switch on the connected display.
For details on how to use your external display, refer to the
owner’s manual for your display.
5.
Set to “RGB” at “Selecting the Video Output
Destination” (p. 40).
Connecting an External Display or a Television
Connecting a Television
Television
VIDEO jack
OUTPUT
(Rear panel)
Video cable
(Commercially available)
Connecting an External Display
Resolution 800 x 480 pixels or more
Horizontal scan rate 31.5 kHz
Vertical scan rate 60 Hz
Connector Three-row 15-pin D-sub type
Signal Analog
External display
ANALOG
RGB OUT
(Rear panel)
Monitor cable
(Commercially available)
RK-300_e.book 39 ページ ２００８年９月１０日 水曜日 午後４時６分