Nortel Networks 1000E - Manual (Page 465)

Configuring IP Peer Networking and managing the Gatekeeper database Page 465 of 466
Communication Server 1000E Installation and Commissioning
5 Configure the Gatekeeper database to provide a central database of
addresses that are required to route calls across the network, using the
Gatekeeper web pages in Element Manager.
a Log in to the Gatekeeper web pages in Element Manager.
b Verify that the Gatekeeper is the Primary Gatekeeper and is active.
c Configure the System Wide Settings.
d Create the CDP domains.
e Add the RAS and non-RAS endpoints.
f Add the endpoint prefixes.
g Add the Numbering Plan entries for each endpoint, including the
Cost Factor for each entry.
h Add the default routes.
i Add the Gatekeeper zones (if required).
j Test the Numbering Plans.
k Perform database cutover.
l Perform the following operations, as necessary:
i. Take the Gatekeeper out-of-service.
ii. Perform database cutover.
iii. Perform database rollback.
iv. View traffic reports.
m Log out of the Gatekeeper web pages in Element Manager.