Nortel Networks 1000E - Manual (Page 271)

Connecting an MRV LX8020S-102AC-R Terminal Server Page 271 of 466
Communication Server 1000E Installation and Commissioning
Telnet Terminal Server virtual management port
Connect the Terminal Server ethernet port to the ELAN subnet using a CAT5
ethernet cable. The virtual management port 0 is accessible from an online PC
using a telnet session. The Terminal Server can now be configured from the
on-line PC.
Procedure 61
Running telnet from PC
1 In Windows, input the Telnet command
>Start > Run
telnet IP address port#
Where:
IP address = Terminal Server IP address
Port# = port no. (calculation of port shown below in Procedure 63 on
page 273
Example: telnet 47.11.244.101 2100 (if it is port 1)
Note: No port is used for the virtual management port.
2 Press until the MRV login prompt appears.
3 Input login password and username to log in to the virtual management
port.
End of Procedure
Telnet to CS 1000E COM port from a PC
Connect port xx (xx = 1 - 20) of the Terminal Server to COM1 port of the
CS 1000E Call Server.