Nortel Networks 1000E - Manual (Page 272)

Page 272 of 466 Connecting an MRV LX8020S-102AC-R Terminal Server
NN43041-310 Standard 01.11 October 2008
Follow Procedure 62 to establish access to a Call Server from a PC through
telnet Terminal Server. Use the same port number for each procedure step.
Procedure 62
Accessing a CS 1000E from a PC through telnet Terminal Server
1 Connect to the management port or virtual management port as shown in
Procedure 61 on
page 271 or Procedure 59 on page 269 .
2 Define the port baud rate to equal the baud rate of the CS 1000E COM
port. Enter:
InReach:0 >>config port async speed
InReach:0 >>config port async 1 speed 9600
Where: xx = Port number from 1-20 and BAUDRATE = the baudrate of
the connected Call Server com port.
3 To avoid autohangup:
InReach:0 >>config port async no autohangup
InReach:0 >>config port async 1 no autohangup
4 Turn off authentication.Then save the configuration and check it:
InReach:0 >> config port async no authentication
outbound
InReach:0 >>save config flash
InReach:0 >>show port async chara
InReach:0 >> config port async 1 no authentication
outbound
InReach:0 >>save config flash
InReach:0 >>show port async 1 chara
5 Run telnet on the PC.
a. In Windows:
Start > Run
b. Enter the Input telnet command.
TELNET xxx.xx.x.xx xxxx
Where: