Nortel Networks 1000E - Manual (Page 457)

Page 457 of 466
Communication Server 1000E Installation and Commissioning
462
Basic system telephony configuration
Contents
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 457
Basic system configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 457
TN assignment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 462
TN assignment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 462
Introduction
This chapter shows overlay (LD) sequences required to configure the system
with basic telephony features. Your Planning and Engineering group provides
the details needed to configure basic telephony.
Note: The Command Line Interface (CLI) must be used for some
configuration (for example, LD 10 and LD 11) before Element Manager
can be used to further configure basic telephony.
This chapter contains Procedure 110: "Configuring the basic system" on
page 458 .
Basic system configuration
Programming the CS 1000E system requires loading different overlay
programs and using each one to enter a specific type of information.