Before you begin, Introduction – Nortel Networks 1000E User Manual
Page 362
Page 362 of 466
Configuring an IP telephony node
NN43041-310
Standard 01.11
October 2008
The preconfigured IP telephony configuration files from the leader Signaling
Server must be imported. These files are saved on the CS 1000E as:
•
c:/u/db/node/nodex.cfg where x is the node number
•
c:/u/db/node/nodex.btp where x is the node number
This chapter contains the following procedures:
•
Procedure 83: "Turning off browser caching in Internet Explorer"
on
•
Procedure 84: "Logging in to Element Manager" on
•
Procedure 85: "Importing an existing node" on
•
Procedure 86: "Reviewing and submitting IP telephony node
configuration" on
•
Procedure 87: "Adding a Follower Signaling Server to the IP telephony
node in Element Manager" on
•
Procedure 88: "Performing a datadump using Element Manager"
on
Before you begin
Perform a datadump
Use Element Manager to perform a datadump before making any changes to
the IP telephony node. A datadump backs up both the IP telephony node
configuration files and the customer database files. The datadump procedure
using Element Manager is outlined in Procedure 88 on
.
Enable the multi-user option
Enable the multi-user option to access Command Line Interface (CLI)
overlays and Element Manager at the same time. For more information about
IMPORTANT!
Do not attempt to alter the configuration files either manually or with
OTM’s ITG or IP Phone management. Use Element Manager only.