beautypg.com

Configuring the ipmg zone and ip address – Nortel Networks 1000E User Manual

Page 147

background image

Installing software on the CS 1000E

Page 147 of 466

Communication Server 1000E

Installation and Commissioning

TLAN set to auto negotiate.

ELAN set to auto negotiate.

ELAN security Enabled, level is Optimized Security

Is this correct? (y/n/[a]bort) : y

4

IP changes require a reboot. Enter “y” at the prompt.

Do you want to continue? (y/n/[a]bort) : y

reboot(-1) has been called...

Following the reboot, the MGC connects to the CS and downloads the
remaining configuration information.

If centralized software upgrade has been enabled, the MGC will upgrade its
loadware by downloading it from the CS.

Once the MGC has registered, the LED display will show the superloop and
shelf (for example: 4 0) of the IPMG. Otherwise, it will show “UNRG.”

Configuring the IPMG zone and IP address

The next step in the process involves configuring the IPMG zone and IP
address in Overlay 97 on the Call Server.

Note: This procedure may be performed through Element Manager
following the installation of the Signaling Server. To configure an IPMG
using Element Manager see Procedure 48 on

page 240

.

1

Log into Overlay 97 to configure the MGC that will register to the call
server:

>LD 97

SCSYS000

MEM AVAIL: (U/P): 103979814 USED U P: 230475 59531

TOT: 104269820

REQ prt

TYPE supl

SUPL

SUPL SUPT SLOT XPEC0 XPEC1 IPMG ZONE0/1 IPR0/1