Nortel Networks 1000E - Manual (Page 256)

Page 256 of 466 Connecting an IR-8020M-101 Terminal Server
NN43041-310 Standard 01.11 October 2008
3 Configure the Terminal Server’s IP primary gateway address. Enter:
define server ip primary gateway address [ip address]
4 Check Terminal Server configuration. Enter:
list server ip
Example commands:
define server ip address 172.16.3.50
define server ip subnet mask 255.255.255.0
define server ip primary gateway address 172.16.3.1
End of Procedure
Telnet Terminal Server virtual management port
Connect the Terminal Server ethernet port to the ELAN using a CAT5
ethernet cable. The virtual management port 0 is accessible from an online PC
using a telnet session. The Terminal Server can now be configured from the
on-line PC.
Procedure 54
Run telnet from PC
1 Use Start > Run
Input telnet command: telnet ip-address port#
Where:
ip-address: Terminal Server IP address
Port#: The target port number on Terminal Server=2000+(xx x 100)
For Terminal Server virtual management port xx=0
Example: telnet 172.16.3.50 2000
2 Press until the MRV login prompt appears.
3 Input login password and username to log in to the virtual management
port. The default password is "access".
End of Procedure