Nortel Networks 1000E - Manual (Page 152)

Page 152 of 466 Configuring the CS 1000E CP PM Call Server
NN43041-310 Standard 01.11 October 2008
Introduction
The CS 1000E system requires the configuration of an IP telephony node.
The configuration data is stored in the BOOTP.TAB and CONFIG.INI files
on the CS 1000E. Copies of both files are maintained on each node
component (Signaling Server and Media Card).
The preconfigured IP telephony configuration files from the leader Signaling
Server must be imported. These files are saved on the CS 1000E as:
• c:/u/db/node/nodex.cfg where x is the node number
• c:/u/db/node/nodex.btp where x is the node number
The node database files are backed up along with the customer database using
the LD 43 EDD command.
This chapter contains the following procedures:
• Procedure 30: "Configuring login IDs and passwords" on page 153
• Procedure 31: "Enabling the multi-user option" on page 156
• Procedure 32: "Configuring pseudo-terminals (PTYs)" on page 157
• Procedure 33: "Checking PTY status" on page 159
• Procedure 34: "Configuring MG 1000E Bandwidth Management Zone"
on
page 161
• Procedure 35: "Launching Element Manager" on page 166
• Procedure 36: "Importing an existing node" on page 168
• Procedure 37: "Performing a datadump using Element Manager"
on
page 170
IMPORTANT!
Do not attempt to alter the configuration files either manually or with
OTM’s ITG or IP Phone management. Use Element Manager only.