Nortel Networks 1000E - Manual (Page 143)

Installing software on the CS 1000E Page 143 of 466
Communication Server 1000E Installation and Commissioning
Perform a customer backup data dump (installation release)
Procedure 28
Performing a data dump to backup the customer database:
1 Log in to the system.
2 Insert a CF card into the active CP PM Call Server RMD slot to back up
the database.
3 Load the Equipment Data Dump Program (LD 43). At the prompt, enter:
4 When “EDD000” appears on the terminal, enter:
5 When “DATADUMP COMPLETE” and “DATABASE BACKUP
COMPLETE” appear on the terminal, enter:
End of Procedure
Configuring initial IP configuration data on MGC
Note: Coordinate all Nars/Bars and NRS changes to ensure that your
cutover plan is designed for minimum downtime.
LD 43 Load program.
. EDD
EDD Begin the data dump.
CAUTION — Service Interruption
Loss of Data
If the data dump is not successful, do not continue;
contact your technical support organization. A data dump
problem must be corrected before proceeding.
**** Exit program
The installation is now complete.