Nortel Networks 1000E - Manual (Page 221)

Installing a Signaling Server Page 221 of 466
Communication Server 1000E Installation and Commissioning
8 Configure the application configuration for this Signaling Server. See
Figure 96.
• If you are planning on enabling the IP Phone TPS, Virtual Trunk TPS,
and optional Network Routing Service (NRS) applications on this
Signaling Server, enter a at the prompt to configure this Signaling
Server as a co-resident Signaling Server.
• If you are planning on enabling only the NRS on this Signaling
Server:
— If this Signaling Server is to be associated with a Call Server,
enter a at the prompt to configure this Signaling Server as a
co-resident Signaling Server. After you finished installing the
Signaling Server software, you can disable the IP Phone TPS
and Virtual Trunk TPS in Element Manager (refer to Element
Manager: System Administration (NN43001-332)).
— If this Signaling Server is not to be associated with a Call Server,
enter b at the prompt to set this Signaling Server as a
Standalone Signaling Server - NRS.
Figure 96
Application configuration
Depending on the application configuration selected, either the
NRS type: co-resident Signaling Server screen (Figure 97 on
page 222 )
or the NRS type: standalone Signaling Server screen (Figure 98 on
page 222 ) appears.
Please enter:
-> - Co-resident (LTPS + VTRK + NRS).
- Stand-alone (NRS only - no Call Server).
- Quit.
Enter Choice>
=====================================================================
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
Please select the application configuration for this Signaling Server.