Nortel Networks 1000E User Manual
Page 276
Page 276 of 466
Connecting an MRV LX8020S-102AC-R Terminal Server
NN43041-310
Standard 01.11
October 2008
Note 1: It is not advisable to use putty software while trying to do rlogin
Note 2: MRV definition of autoconnect: In Procedure 62 on
and Procedure 63 on
this feature of autoconnect is required.
This command is used to specify whether or not the port will automatically
connect to either a dedicated service or a preferred service when the user logs
onto a port. Autoconnect is automatically enabled for a port when a dedicated
or preferred service is defined for that port. However, it is not disabled when
service is disabled.Autoconnect also specifies whether or not the port should
attempt to re-connect a session when a connection failure occurs.
Re-connection attempts occur at intervals specified by the SERVER
KEEPALIVE TIMER command (between 10 and 180 seconds), and a status
message displays whenever ports that are not configured with a dedicated
service attempt to connect (no messages are given for ports that are
configured with a dedicated service). Re-connection attempts continue until a
connection is made or the user terminates further attempts by entering the
local command mode.
Finally, Autoconnect helps control In-Reach Element Manager activity when
the port uses modem control signals (for example, a port connected to a
dial-up line). Before you can enable Autoconnect, you must define the port for
LOCAL access, enable MODEM CONTROL, and define a dedicated service.
End of Procedure
Accessing an MRV Console Port through the
on-board modem
Procedure 64
Accessing an MRV Console Port through the on-board modem
1
Connect an analog phone line to the MRV phone line (Telco) port.
2
Set up the rlogin connection using Procedure 63 on
3
Dial in to the MRV onboard modem from the PC. This can be done after
configuring the modem port as Rlogin.
4
From the PC, run HyperTerminal. Enter the command:
ATD [phone no.]
Screen response:
CONNECT 9600/ARQ/V34/LAPM/V42BIS