Nortel Networks 1000E - Manual (Page 451)

Page 451 of 466
Communication Server 1000E Installation and Commissioning
456
Installing and cross-connecting
an external alarm from a PFTU
Contents
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 451
Installing an alarm using an alarm port assigned in LD 15. . . . . . . . . . 452
Installing an alarm through QUA6 PFTU connections . . . . . . . . . . . . . 453
Introduction
This chapter describes the procedures for connecting an external alarm to the
CS 1000E system.
This chapter contains the following procedure: Procedure 109: "Installing an
alarm using an alarm port assigned in LD 15" on
page 452
The following are the two methods of connecting an external alarm to the
CS 1000E system:
• through an alarm port assigned in software
• through contacts in a QUA6 Power Failure Transfer Unit (PFTU)