Nortel Networks 1000E - Manual (Page 431)

Installing and configuring Nortel IP Phones Page 431 of 466
Communication Server 1000E Installation and Commissioning
Node: x
TN: x.x
1 Enter the node number and the Nortel IP Phone's (virtual) TN, then go to
Step 4.
If you configured a Nortel IP Phone Installer Password, the Nortel IP
Phone prompts:
Node: x
PassWord: 0
2 Enter the node number and the temporary or administrator Nortel IP
Phone Installer Password.
Note 1: An asterisk is displayed for each password digit entered; the
actual password is not displayed.
Note 2: If this screen times-out, or if you do not successfully enter the
password in 3 attempts, the Nortel IP Phone continues its registration
process as if no entry had been made to this prompt. You can reboot the
telephone and try again if more tries are needed.
The Nortel IP Phone prompts:
TN: x.x
3 Enter the Nortel IP Phone’s (virtual) TN.
4 Press the OK key.
The Nortel IP Phone responds Unequipped...
5 Lift the handset. The system accepts the TN.
6 Listen for the continuous dial tone.
The system response, displayed on the Nortel IP Phone, is as follows:
Model ? (20)
7 Press the # key to select the default model, or enter the model number
and press #.
8 Listen for a special tone.
The system response, displayed on the Nortel IP Phone, is as follows:
OK, ZONE? (0)
9 Press the # key to select the default zone, or enter the zone number and
press #.