Nortel Networks 1000E - Manual (Page 279)

Page 279 of 466
Communication Server 1000E Installation and Commissioning
286
Configuring a terminal and SDI ports
Contents
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 279
Setting the TTY terminal port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 280
Traditional terminal SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . . 280
CS 1000E CP PM Call Server COM Port connections. . . . . . . . . . . . . 281
MG 1000E SDI connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 282
Controlling the baud rate. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 283
BayStack 470 SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 285
BayStack 470 SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 285
Media Card SDI connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 285
Introduction
In the CS 1000E system, each component (CP PM Call Server, MG 1000E,
Signaling Server, and Baystack switch) has a Serial Data Interface (SDI) port
to be used for software installation and maintenance access. The SDI port can
be accessed by running a Telnet session through the Terminal Server locally
or remotely. See “Configuring a Terminal Server” on
page 253 for Terminal
Server Setup. The SDI port can also be accessed by a local terminal through
the SDI connection.